Report codes are required in fields *61, *65, *71, *72,įor UL Commercial Burglar Alarm installations. An entry of 0 in the first box disables the report. This is an “enabling” code only and is not the actual code sent to the Central Station office. ![]() If the number of zones exceeds the number of available digits, begin with digit 1 again. Use a different digit for each zone until you have used up available digits. ADEMCO Contact ID® Reporting: Enter a digit in the first box to enable the zone to report. A 0 in the second box eliminates the expanded message for that report. Expanded or 4+2 Format: Enter codes in both boxes (first/second digits) for 1–9 or A–F, as described above. Entering 0 in the second box advance to the next field. An entry of 0 in the first box disables a report. Enter #+10 for A (this reports a 0 on some receivers), #+11 for B, #+12 for C, #+13 for D, #+14 for E, #+15 for F. 3+1 or 4+1 Standard Format: Enter a code in the first box: 1–9, A, B, C, D, E, or F. The actual report code digits that you enter depend upon the particular installation, and should agree with the Central Station office receiving the signals. ![]() ![]() ✱56 or ✱58 Zone Programming modes, while system status (non-alarm) codes and restore codes are entered in data fields *59 - *68, *70 - *76, *89. Zone report codes are programmed using interactive
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |